Felt furniture pads. First, adjust your shower curtain to be a few inches longer than the shower. Hang the shower curtain rod at an angle, with one end several inches higher than you want it. Slowly slide that end down until the rod is hanging straight. The felt pads keep it from sliding futher down the tile wall.Click to see full answer. Subsequently, one may also ask, how do you tighten a shower curtain rod?Hold the rod in place with the curtain about an inch off the floor, then twist the smaller rod counterclockwise to lengthen it. Keep twisting after both ends have made contact with the walls until the rod has enough tension to stay in place. do tension shower rods work on tile? You don’t need to drill holes in your bathroom or damage your tiles. These tension rods work on most surfaces – tile, wallpaper, wood, smooth walls, and more. The spring-loaded tension keeps them steady and in place. Beside above, how do I make my tension rod stay up? Locate the point where the two sections of the tension rod fit together. Tension rods have two interlocking shafts with a strong spring inside. Place one hand on either side of the spot where the rods connect and twist counterclockwise to lengthen the tension rod or clockwise to shorten it.How do you put a shower rod back together? Tension Rods Measure the distance between the two walls where the shower rod must be mounted with a tape measure. Unscrew the rod by turning each end in an opposite direction so the rod opens or extends. Hold the shower curtain against one wall directly above the tub’s apron or exposed edge as a guide.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6wn7JllKSytHnMsmSsoJ%2BssrN50aibZqOVmr20ecWao6Whnpx8